EarthQuake PH2200W.4 Spezifikationen Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 10
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
PH10000W/ 1D
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
DO NOT SOLDER THE TIP OF THE POWER
CABLE (+&-). IT REDUCES THE CONTACT
SURFACE BETWEEN THE CABLE AND THE
INSIDE OF THE TERMINAL. WHEN
TIGHTENING THE SCREW, A RAW CABLE (NO
SOLDER) EXPANDS INSIDE THE TERMINAL
CREATING LARGER CONTACT SURFACE;
THUS ELIMINATING HOT JUNCTIONS.
To car chassis / ground
To remote turn on / triggerSpeaker output
To battery (+)
REM
GND BAT
"RCA level" audio signal needed to clip the input stage (bass boost at minimum)
"RCA level" audio signal needed to clip the input stage (bass boost at maximum)
"SPEAKER level" audio signal needed to clip the input stage (bass boost at minimum)
"SPEAKER level" audio signal needed to clip the input stage (bass boost at maximum)
High Level
speaker input
RCA, Low
Level input
RCA, Low
Level out
This switch will reverse the phase of PH10000's
output with respect to its input. Although the position
that yields the most upper bass is technically correct,
you may choose the position that better suits your
needs.
Peaks or dips occur at about 40Hz —
around the frequency of a low bass
guitar note. Use this control
to correct that peak or dip.
The low-pass filter,
blocks unwanted high
frequencies to allow
cleaner low-frequencies.
This switch will line
match the voltage of your
head unit, which will
deliver high sound quality
and performance.
16 17
Specifications Are Subject To Change Without Notice www.earthquakesound.com
FUSE RATING SHOULD BE
NO LESS THAN 120 AMPERES
PER AMPLIFIER
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare