Earthquake 600050V Bedienungsanleitung PDF herunterladen (Seite 13)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 13

Operator's Manual

String Mower 600050V

FIGURE 14: Mower head and mower line

MOWER HEAD SERVICE AND ADJUSTMENT,

SLIDE-THROUGH VERSION

Replace Mower Line on Slide-Through Version

For the best performance, use a heavy gauge (0.155" diameter)

mowerCutthelengthofthemowerlineto15".Usethelength

guide, located on the shield, to make sure the mower line is the

correct length. Place one end of the mower line at location “A”

and bend it along the raised portion of the shield. Cut line at

location “B”. SEE FIGURE13

NOTE: Do not allow the length of the lines to vary more than

one inch. This is important to make sure the mower head is

balanced and does not vibrate.

To extend the life of the mower line, keep the mower line

moist. If not kept moist, the nylon mower line will become

dry and brittle. Keep extra mower line in a can of water. The

line will then stay flexible and easy to change. A flexible line

will also last much longer.

Familiarize yourself with the mower head. (SEE FIGURE 14)

Mower head has four small exit holes and four large entrance

holes. Properly loaded mower line will have 1” exposed out the

small exit hole and the remaining portion of the line sticking out

of the large entrance hole.

1. Before replacing the mower line make sure the engine is

stopped and wait for all moving parts to come to a stop.

2. Remove worn mower line from the line retainer by pulling

on exposed 1” line from outfeed hole. SEE FIGURE 15

3. Push one end of the new mower line through the insertion

hole in the head. SEE FIGURE 16

4. Push the line in until approximately 1” is exposed on the

outfeed side.

5. Repeat for each of the four locations. Make sure the line

length is the same at all four locations.

WARNING

BEFORE YOU INSPECT, CLEAN OR SERVICE THE

MOWER, STOP THE ENGINE. MAKE SURE THAT ALL

MOVING PARTS HAVE STOPPED. DISCONNECT THE

WIRE FROM THE SPARK PLUG.

FIGURE 16: Insert new mower line into entrance hole

ENTRANCE HOLE

EXIT HOLE

1" OF EXPOSED

MOWER LINE ON

EXIT HOLE SIDE

REMAINING MOWER

LINE ON ENTRANCE

HOLE SIDE

EXIT HOLE

FIGURE 15: Pull old mower line out through exit hole

ENTRANCE

HOLE

STOP WITH 1" EXPOSED

OUTEXITHOLE

FIGURE 13: Mower Line 15” Measurement Guide

To Detach the Wheels

To detach the wheels, loosen the axle nuts and remove the

wheel, spacer and lockwasher. Reverse instructions to reattach

tire. SEE FIGURE 17

AXLE NUT

SPACER

LOCKWASHER

FIGURE 17: Removing the Wheels.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Earthquake 600050V Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartengeräte Earthquake 600050V