Earthquake 600050V Bedienungsanleitung PDF herunterladen (Seite 12)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-512

Operator's Manual

String Mower 600050V

How to Change Engine Oil

Be sure the engine is not operating and is located on a level surface

before checking or refilling oil. Engine should be warm for easy

removal of oil.

1. Detach spark plug wire and move away from spark plug. If the

engine uses a battery, disconnect at negative terminal.

2. Remove dipstick and carefully tip the engine toward the dipstick

side to empty oil from oil fill area. Empty oil into a suitable oil

container and dispose of oil properly. SEE FIGURE 7

3. Tip engine back onto a level surface and fill with appropriate

oil to the top of the marking on the dipstick (SEE FIGURE 8).

DO NOT OVERFILL. For proper oil capacity, see the engine

manufacturer's instructions.

4. Reinsert dipstick and tighten. SEE FIGURE 8

How to Replace the Mower Line on Standard Head

For the best performance, use a heavy gauge (0.155" diameter)

mowerline.Cutthe lengthofthe mowerlineto 21.5".Usethe

length guide, located on the shield, to make sure the mower line

is the correct length. Place one end of the mower line at location

“A” and bend it along the raised portion of the shield. Cut line at

location “B”. SEE FIGURE 9

Do not allow the length of the lines to vary more than 1”. This is

important to make sure the mower head is balanced and does

not vibrate.

NOTE: To extend the life of the mower line, keep the mower

line moist. If not kept moist, the nylon mower line will

become dry and brittle. Keep extra mower line in a can of

water. The line will then stay flexible and easy to change. A

flexible line will also last much longer.

1. Stop the engine. Wait for all moving parts to stop.

2. Remove the worn mower line from the line retainer.

3. First, thread the ends of the new mower line through the

outside loops. SEE FIGURE 10

4. Next, take the ends of the line, cross over the line retainer, and

thread the ends through the center hold. SEE FIGURE 11

5. Then, check to make sure that the ends of the line are even.

SEE FIGURE 12

SERVICE AND ADJUSTMENT

FIGURE 12: Check Ends Of Line.FIGURE 11: Threading Mower Line Through Center

Hold.

FIGURE 10: Threading The New Mower Line.

LINE

RETAINER

MOWER

LINE

WARNING

BEFORE YOU INSPECT, CLEAN OR SERVICE THE

MOWER, STOP THE ENGINE. MAKE SURE THAT ALL

MOVING PARTS HAVE STOPPED. DISCONNECT THE

WIRE FROM THE SPARK PLUG.

CAP

SCREWS

FIGURE 8: Dipstick And Oil Levels.

Upper Level

Lower Level

Oil Dipstick

Oil Fill Spout

19444-0012r1

OIL

DIPSTICK

FIGURE 7: Oil Dipstick Location

CAP

SCREWS

CAP

SCREWS

LINE

RETAINER

FIGURE 9: Mower Line 21.5” Measurement Guide

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Earthquake 600050V Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartengeräte Earthquake 600050V