Page 10
OPERATOR INSTRUCTIONS AND PARTS
WE43E & WE43 Edger
800-345-6007
UNPACKING AND ASSEMBLY
UNPACK EDGER
1. Set aside the operators manual and parts bag. Carefully
lift the edger out of the box, remove any packing
material and cut any ties holding the handlebar pieces
to the edger assembly.
ASSEMBLY
1. Stand the edger assembly upright with wheels on a
level surface. DO NOT place the edger on a high
surface where it can fall and cause property
damage or personal injury.
2. Unscrew knob from height adjustment bar. Slide height
adjuster bar through slots in wheel mount bracket with
wheel placed towards edger blade guard. Place knob
with bolt through hole at top of height adjuster bar from
engine side and secure with nut. Adjust height of unit
and place detent pin through matching holes in height
adjuster bar and wheel mount bracket. Refer to photo
on page 17 for proper placement.
3. Using two tee handle nuts (4640), two bolts (4642),
and two curved washers (4641), assemble the middle
handlebar (4693) to the handlebar & wheel mount
weldment (400008) that is already attached to the edger
assembly. The middle handlebar can be installed in two
positions one high and one low. DO NOT overtighten
the tee handle nuts.
4. Attach the upper right and left handlebars (4689 &
4690) to the middle handlebar using the two remaining
tee handle nuts, bolts, and curved washers. DO NOT
overtighten the tee handle nuts.
5. Secure cable to handlebar with provided cable tie.
For the Electric Start Edger Model WE43E, remove the
battery box cover and plug the white plastic connector
from the battery into the mating white plastic connector
in the battery box. See Figure 1. Make sure the ignition
key is removed from the ignition before connecting
the wiring for the battery.
Figure 1
FOR MODEL WE43E ELECTRIC START
CHARGING THE BATTERY
To charge the battery, check that the battery wiring is
properly connected and plug the battery charger (4681)
into the side of the battery box (4656) with matching
three-prong plug. Plug the other end of the battery
charger into a standard 120V outlet receptacle. Battery
is fully charged when the LED light turns GREEN on
the external charger. The electric start mini cultivator
(MC43E) will maintain a charge in the battery when the
engine is running.
Batteries may take as long as 8 hours to fully charge
depending on the original charge level of the battery.
NOTE: For long term storage protection, be sure
that the battery is fully charged and the white plastic
battery connector is disconnected. Place the battery
box cover onto the battery box and store in a dry
place out of direct sunlight.
NOTE: Rechargeable batteries have a limited number
of charge cycles and may eventually need to be
replaced. Battery life and number of charge cycles
vary by use.
IMPORTANT
DO NOT SPRAY WATER ON OR NEAR THE ELECTRONICS
OF THE EDGER AS THIS MAY RESULT IN DAMAGE TO
THE ELECTRICAL COMPONENTS.
DO NOT TRY TO START ENGINE WHILE THE BATTERY
CHARGER IS CONNECTED. THIS COULD DAMAGE THE
ENGINE AND BATTERY.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern