EarthQuake WE43 Spezifikationen PDF herunterladen (Seite 15)

OPERATOR INSTRUCTIONS AND PARTS

WE43E & WE43 Edger

Page 15

GetEarthquake.com

800-345-6007

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE REMEDY/ACTION

Engine will not start 1. Power switch off 1. Flip switch to ON position

2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug

3. Out of fuel 3. Refuel

4. Spark plug wet, faulty or improperly

gapped

4. Clean, replace or gap spark plug

5. Throttle control not held open 5. Hold throttle control open when pulling recoil

handle

6. Fuel line hose not positioned in bot-

tom of gas tank

6. Push fuel line down into fuel in gas tank

Engine runs rough, ﬂoods during

operation

1. Dirty air ﬁlter 1. Clean or replace air ﬁlter

2. Choke partially engaged 2. Turn off choke

3. Carburetor out of adjustment 3. Call factory

Engine is hard to start 1. Stale fuel 1. Drain old fuel and replace with fresh.

Use gas stabilizer at end of season

2. Spark plug wire loose 2. Make sure spark wire is securely attached to

spark plug

3. Dirty carburetor 3. Clean carburetor, use gas stabilizer, new gas can

4. Throttle control not held open 4. Prime unit 3 more times, then hold throttle open

when pulling recoil handle

Engine misses or lacks power 1. Clogged gas tank 1. Remove and clean gas tank

2. Clogged air ﬁlter 2. Clean or replace air ﬁlter

3. Carburetor out of adjustment or bad 3. Call factory

4. Spark plug wet, faulty or improperly

gapped

4. Clean, replace or gap spark plug

Engine runs, then quits 1. Gas cap not venting 1. Clean or replace gas cap, check vent

2. Plugged fuel ﬁlter 2. Clean or replace fuel ﬁlter

3. Carburetor out of adjustment or bad 3. Call factory

Engine revs too high 1. Carburetor out of adjustment 1. Call factory

Edger blade turn at idle 1. Idle speed too high 1. Adjust idle speed lower

2. Broken clutch spring 2. Replace spring

Edger blade fails to turn 1. Jammed, foreign object in blade

area

1. Clear obstruction

Edger blade fails to cut properly 1. Blade worn out 1. Replace blade

2. Blade wobbles 2. Replace clamp washer, tighten nut

MODEL WE43E ONLY

Charger won’t charge 1. Battery worn out 1. Replace with new batttery

2. Connectors not plugged in 2. Open battery box and connect battery connectors

Key won’t start machine 2. Battery not charged 1. Charge battery

Contact service provider at 800-345-6007 if above remedies fail.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

EarthQuake WE43 Spezifikationen Seite 15

Kommentare zu diesen Handbüchern